RC Pro™

RC Pro technology allows Varel design engineers to develop and fully optimize a roller cone cutting structure and bearing design for a specific application. Information generated within RC Pro is then delivered to Varel’s advanced modeling roller cone software drilling package for further refining.

Table Image

Quality, Consistency, and Accuracy are important, and RC Pro takes it to a new level with programmed standards and best practices to help engineers generate the best possible cutting structure and bearing package. Engineering inputs for RC Pro are not limited by these standards and allow for the best design possible for the application. With our dedication to be responsive, reliable, and innovative, RC Pro assist engineers to deliver the best products possible.

Table Image

Parts are easily entered in RC Pro allowing the engineer to custom design parts as needed. This gives the engineer full control of the cutting structure and bearing package parts to create the optimum design for the application. All opportunities with the design are explored with standards and best practices kept in the forefront of the design stream to help construct a solidly designed bit.

Table Image

The engineer will make the hard choices of the design and promote them to the finished design in RC Pro. With the design being completed, tooth spacing, overlap, interference, and minimum section between cutters and bearing parts have checked. The next step is to enlist AMP. The Advanced Modeling Package will virtually run the design in the application. If the bit proves to be the best design it will be manufactured and delivered to the customer.